Santec TSL-710 - Page 105

Tunable Semiconductor Laser TSL-710
7-51
LP Syntax LP<value>
 Description SetstheopticaloutputpowerinmW.
   Whenparameterisnotspecied,readsouttheactualpowervalue.
 Parameter Range: 0.01~10mW(typical)
   Step: 0.01(mW)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setstheopticaloutputpowerto10mW.
LP10
   Readsouttheactualpowervalue.
LP
→010.005
   Indicatesthattheactualpowervalueis10.005mW.
AF Syntax AF
 Description SetsthepowercontroltoAuto.
Parameter None
Response None
AO Syntax AO
 Description SetsthepowercontroltoManual.
Parameter None
Response None
AT Syntax AT<value>
 Description Setstheinternalattenuatorvalue.
   Whenparameterisnotspecied,readsoutthevaluecurrentlyset.
 Parameter Range: 0~30(dB)
   Step: 0.01(dB)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setstheinternalattenuatorvalueto3dB.
AT3
Reads out the currently set value
AT
→010.000
    Indicatesthatthecurrentlysetattenuatorvalueis10dB.
SC Syntax SC
 Description SetsCLOSEstatusoftheinternalshutter.
Parameter None
Response None