Santec TSL-710 - Page 104

7-50
TSL-710 Operation Manual
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsoutputfrequencyto192.0000THz.
    FQ192.0000
Reads out the currently set value
FQ
→ 192.0000
   Indicatesthatthecurrentlysetfrequencyis192.0000THz.
FT Syntax FT<value>
 Description SetstheFine-Tuningvalue.
   Whenparameterisnotspecied,readsoutthevaluecurrentlyset.
 Parameter Range: -100~+100
   Step: 0.01
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example SetstheFine-Tuningvalueto–50.
FT-50
Reads out the currently set value
FT
→ 0100.00
   Indicatesthatthecurrentlysetvalueis100.
FTF Syntax FTF
 Description StopsFine-tuningmode,andstartsclosed-loopwavelengthcontrolling.
Paramete None
Response None
OP Syntax OP<value>
 Description SetstheopticaloutputpowerindBm.
   Whenparameterisnotspecied,readsouttheactualpowervalue.
 Parameter Range: -20~+10dBm(typical)
   Step: 0.01(dB)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setstheopticaloutputpowerto+3dBm.
OP3
   Readsouttheactualpowervalue.
OP
→ 002.995
   Indicatesthattheactualpowervalueis2.995dBm.