Santec TSL-710 - Page 86

7-32
TSL-710 Operation Manual
[:SOURce]:POWer:ATTenuation
Syntax
[:SOURce] :POWer: ATTenuation <wsp> <value>
Description Sets the attenuator value.
Parameter Range：0 〜 3 0 (dB)
Step：0.01 (dB)
Response None
Example :POW:ATT 10
Sets the attenuator value to 10 dB.
[:SOURce]:POWer:ATTenuation?
Syntax [:SOURce]:POWer:ATTenuation?
Description Reads out the attenuator value.
Parameter None
Response Range：0 〜 30 (dB)
Step：0.01 （dB）
Example : POW: ATT?
→10.000
Indicates that the attenuator value is 10 dB.
[:SOURce]:POWer:ATTenuation:AUTo
Syntax [:SOURce]:POWer:ATTenuation:AUTo<wsp><value>
Description Switches to Auto/Manual for the power
control.
Parameter 0：Manual
1：Auto
Response None
Example :POW:ATT:AUT 1
Sets the power control to Auto.
[:SOURce]:POWer:ATTenuation:AUTo?
Syntax [:SOURce]:POWer:ATTenuation:AUTo?
Description Reads out the setting of the power control.
Parameter None
Response 0：Manual
1：Auto
Example : POW: ATT: AUT?