98 Programming SATEL
No module restart reports [No rest. mon.] – when this option is enabled and the Contact ID
or SIA format is used for reporting, no event codes referring to module restarts will be sent
to the monitoring station.
Advanced
Long kiss-off signal – with this option enabled, the control panel will accept a long kiss-off
(acknowledgment) signal for receiving events in case of Ademco Express and Contact ID
formats. Enable this option in the event of telephone reporting if the monitoring station
acknowledges receiving events in a non-standard way (the kiss-off signal is longer than
800 ms).
Longer waiting for initial handshake – with this option enabled, the control panel will wait
longer for handshake from the monitoring station in case of sending events in the Ademco
Express, Contact ID or SIA format. Enable this option in the event of telephone reporting, if
the monitoring station sends a non-standard initial handshake.
Identifier confirmation required – the option refers to the SIA format. If it is enabled, the
control panel waits for acknowledgement by the monitoring station of receiving the
identifier with which the data were sent. The option refers to the telephone reporting.
6-character identifier – the option refers to the SIA format. If it is enabled, events will be
sent with a 6-character identifier. It consists of 2 parts: 2-character prefix and 4-character
identifier.
Send event source name – the option refers to the SIA format. If it is enabled, the name of
event source (zone, user, etc.) will also be sent along with the event code.
Send event partition name – the option refers to the SIA format. If it is enabled, the name of
partition where the event occurred will also be sent along with the event code.
Each data block conf. required – the option refers to the SIA format. If it is enabled, the
control panel waits for acknowledgement by the monitoring station of receiving each data
block. The option refers to the telephone reporting.
Extended charset – the option refers to the SIA format. If it is enabled, not only ASCII
characters, but also national characters can be sent.
12.1.2 Monitoring station 1 / Monitoring station 2
Reporting format [Tel. 1 format] – format in which event codes are sent to the monitoring
station.
Having selected the CONTACT ID (FULL) or SIA (FULL) format you do not need to
program the assignment of identifiers and any event codes. The control panel will send
the codes according to the format specification and the performed subdivision into
objects.
In the TELIM format, events can only be sent via the analog telephone line.
Telephone
Backup tel. no. [Tel. 2 number] – a backup telephone number of the monitoring station. The
control panel will make an attempt of reporting to that telephone number, if the attempt of
reporting to the basic telephone number fails.
Backup format [Tel. 2 format] – format in which event codes are sent to the backup
telephone number of the monitoring station.
Repetitions [Repetition count] – the number of attempts to establish telephone connection
with the monitoring station after which, if there is no connection (busy number, no
answer from the station, etc.), the control panel will suspend reporting. Up to 31 retries
can be programmed. Programming the value 0 means that monitoring will be suspended
after 8 attempts.
To Next Page
Loading...
