Satel Integra 64 - Entering Names

SATEL INTEGRA 27
Characters available after next keystroke
key
mode [ABC]
key
mode [abc]
1
1
#
1
1
#
2
2
B
C
2
2
a
b
c
3
3
D
E
F
3
3
d
4
4
4
4
5
5
5
5
6
6
6
6
7
7
7
7
8
8
8
8
9
9
9
9
0
0
0
0
Table 1. Characters available in the keypad when entering telephone numbers (to change the
letter case, press ).
Special character
Function description
B
switch-over to pulse dialing
C
switch-over to tone dialing (DTMF)
D
waiting for additional signal
E
3 second pause
F
10 second pause
signal in DTMF mode
#
signal # in DTMF mode
a
b
c
d
other signals generated in DTMF mode
Table 2. Special character functions.
Do not program the B and C characters before the telephone number. The control
panel is dialing the number according to the settings of telephone options. These
characters should be used, if the number dialing method must be changed during the
process of dialing.
2.6.5 Entering names
Keep pressing the key until the required character appears. Characters available in the
keypad are presented in Table 3. Hold down the key to display the digit assigned to the key.
Shown on the left side in the upper line of the display is information about the letter case:
[ABC] or [abc] (it will be displayed after pressing any key and will be visible for a few seconds
after the last keystroke).
The  key moves the cursor to the right, and the  key – to the left. The  key deletes the
character on the left side of the cursor.