86 Programming SATEL
Event after 3 readings [Ev.3 unk.cards] – if this option is enabled, reading in an unknown
card three times will save the event.
Alarm after 3 readings [Al.3 unk.cards] – if this option is enabled, reading in an unknown
card three times will trigger an alarm. The option is available, if the EVENT AFTER 3
READINGS
option is enabled.
Code+card
Code OR card – the user can use code or card for authentication.
Code AND card – the user must use code and card for authentication.
Follow output – the authentication method depends on the status of selected output (the
output active – code and card; the output inactive – code or card).
In case of the authentication using code and card, the executed function depends on
the second identifier.
9. ABAX system – INTEGRA 128-WRL control panel mainboard
The parameters and options of the ABAX system and wireless devices supported by
INTEGRA 128-WRL control panel mainboard can be programmed:
• using the keypad, in the service mode, by means of the functions available in the ABAX -
INTEGRA submenu (STRUCTURE HARDWARE EXPANDERS SETTINGS ABAX -
INTEGRA),
• using the DLOADX program, in the “Structure” window, “Hardware” tab, after clicking on
the “Wireless System”.
The procedures of adding / deleting the ABAX 2 / ABAX wireless devices are described in the
INTEGRA 128-WRL installer manual.
The procedures of adding / deleting and configuring the ABAX 2 / ABAX keyfobs are
described in the user manual. You can define the list of outputs whose status is to be
presented by the ABAX 2 / ABAX keyfob LEDs:
• using the keypad, in the service mode, by means of the ABAX CONFIRMAT. function
(STRUCTURE HARDWARE EXPANDERS ABAX CONFIRMAT.),
• using the DLOADX program, in the “Keyfobs ABAX” window (the command for opening
this window is available in the “Users” menu).
When connecting the ABAX 2 / ABAX controller to the INTEGRA 128-WRL control
panel, you should synchronize the data related to APT-200 / APT-100 keyfobs. In the
keypad, in the service mode, the COPY ABAX KFOBS FUNCTION is available
(
STRUCTURE
HARDWARE
EXPANDERS
COPY ABAX KFOBS), which enables
copying the keyfob related data. In the DLOADX program, to write to a new controller
the data about APT-200 / APT-100 keyfobs already assigned to the users, click on the
“Write to all” button in the “Keyfobs ABAX” window.
9.1 Parameters and options of ABAX system
Assigned to partition – partition in which an alarm will be triggered if the ABAX system is
jammed.
Response period – communication with wireless devices takes place in specified intervals.
The control panel is then gathering information on the status of wireless devices and, if
necessary, sending commands to the devices, e.g. switching the detectors to their
active/passive state, switching on/off the test mode and/or changing configuration of the
devices. The response period can be 12, 24 or 36 seconds. The less often communication
between the control panel and the wireless devices takes place, the more wireless devices
To Next Page
Loading...
