Satel Integra 64 - General; Configuring the Control Panel with Keypad; Starting the Service Mode

SATEL INTEGRA 5
1. General
This manual applies to the control panels of the INTEGRA series:
– INTEGRA 24
– INTEGRA 32
– INTEGRA 64
– INTEGRA 128
– INTEGRA 128-WRL
The control panel may be programmed:
• locally
– LCD keypad,
– computer with the DLOADX program installed, connected to the control panel RS-232
port,
• remotely
– computer with the DLOADX program installed, communicating via the PSTN network
(modem), the cellular network (modem / LTE/GPRS transmission) or the Ethernet
network. Modem communication can take place via the built-in control panel modem or
an external modem connected to the control panel. The LTE/GPRS transmission is
available for the INTEGRA 128-WRL control panel, and also for any control panel if the
INT-GSM / INT-GSM LTE module or the SATEL GSM module is installed in the alarm
system. Communication via Ethernet is possible if the ETHM-1 Plus / ETHM-1 module
is connected to the control panel.
– virtual keypad available in the internet browser, mobile phone or smartphone.
Programming the control panel is possible when:
– the PERMANENT SERVICE ACCESS option is enabled (the option is enabled by default – the
control panel can be programmed by any method),
– the PERMANENT DLOADX ACCESS option is enabled (the option is enabled by default –
the control panel can only be programmed by means of the DLOADX program),
– the installer has been granted a temporary access to the control panel using the
SERVICE ACCESS function (the control panel can be programmed by any method).
The standards require that the administrators (masters) limit the installer access after
installation is finished.
2. Configuring the control panel with keypad
Programming the control panel with keypad (real or virtual) should be carried out using the
service functions, available in the service mode menu. Some features may not be available in
the virtual keypads.
2.1 Starting the service mode
1. Enter the service code (by default 12345) and press the key.
2. Using the  or  key, select the item SERVICE MODE from the list and press the or 
key.
You can also start the service mode using the key shortcut:
[service code] 9
The service mode is indicated in the keypads by lighting of the LED. It can also be
signaled by beeps if the appropriate option is enabled.