Satel Integra 64 - Manual Update History

112 Programming SATEL
If the firmware update is suddenly terminated (e.g. due to loss of power) and, as
a result, the control panel firmware is damaged, the STARTER program will start
automatically and will remain active until the correct firmware is installed.
You can run the STARTER program by shorting the RESET pins when starting
the control panel – remove the short immediately after power-up (within approx.
one second).
17. Manual update history
Date
Firmware
version
Introduced changes
2013-08
1.12
•
Section “Hiding the service mode” has been added (p. 6).
• List of functions available in the service mode menu has been supplemented
(p. 7-25).
• Description of how to configure the GSM module for GPRS remote
programming has been modified (p. 45).
• Description of 3. I
NTERIOR DELAYED type zone has been modified (p. 54).
• Description of 93. O
UTPUTS GROUP ON type zone has been added (p. 57).
• Description of D
ELAY IN 2&3 TYPE ARMING option has been added (p. 58).
• Description of 95. IP
REPORTING TROUBLE type output has been modified
(p. 65).
• Description of R
EPORTING – ETHM-1 option has been modified (p. 71).
• Description of R
ETURN TO MENU FROM MENU “TEST” has been modified (p. 74).
• Description of G
RADE 2 option has been modified (p. 75).
• Description of T
AMPER IF NO COMMUNICATION WITH ABAX DEVICE (2H) option
has been added (p. 76).
• Description of H
IDE SERVICE MODE AFTER option has been modified (p. 78).
• Description of D
O NOT REPORT TIME SERVER TROUBLE option has been added
(p. 77).
• Description of timer exceptions has been modified (p. 95).
• Description of IP
FORMAT parameter has been added (p. 99).
• Description of P
ROTOCOL parameter has been added (p. 99).
• Section describing additional parameters for SIA-IP reporting has been
added (p. 100).
• Section on reporting via Ethernet has been modified (p. 102).
•
Section on GPRS reporting stating has been modified (p. 102).
2013-12
1.12
•
Information on the INT-KLFR , INT-TSG and INT-TSI keypads has been
added.
•
Information on INT-RS Plus module has been added.
2014-10
1.13
• Information on ACU-120 and ACU-270 controllers has been added.
• Information on ETHM-1 Plus module has been added.
• List of functions available in the service mode menu has been supplemented
(p. 7-25).
• Information on new functionality of key 0 when editing the multiple selection
list in text mode has been added (p. 26).
• Description of E
NTRY DELAY parameter has been modified (p. 52).
• Description of E
NTRY/EXIT INTERIOR zone type has been added (p. 57).
• Description of W
ITH VERIFICATION option has been modified (p. 58).
• Description of B
LOCKS VERIFICATION option has been modified (p. 59).
• Description of G
RADE 2 option has been modified (p. 74).
• Description of N
O SHORTCUTS IN MENU option has been added (p. 76).
•
Description of E
XTENDED CHARSET
option has been added (p. 98).