SATEL INTEGRA 105
6. In the settings of the INT-GSM / INT-GSM LTE module (INT-GSM / INT-GSM LTE module
connected to the control panel) or ETHM-1 Plus module (INT-GSM / INT-GSM LTE
module connected to the ETHM-1 Plus module):
– specify the priority of the SMS reporting,
– program the telephone number to which the SMS messages will be sent,
– configure the SMS message format.
13. Messaging
The control panel can inform the users about the system events by means of:
• voice messages. You must connect to the control panel:
– the INT-VG module or another voice synthesizer,
– in case of the INTEGRA 128, INTEGRA 64, INTEGRA 32 and INTEGRA 24 control
panel: telephone line or SATEL GSM module.
• PAGER type text messages, whose content can be programmed (the SATEL GSM
modules enable the PAGER messages to be converted into SMS). In case of the
INTEGRA 128, INTEGRA 64, INTEGRA 32 and INTEGRA 24 control panels, connection
of telephone line or SATEL GSM module to the control panel is required.
• SMS messages, whose content can be programmed. only INTEGRA 128-WRL
• SMS messages, whose content is created automatically, based on descriptions from the
control panel event log memory. The INT-GSM / INT-GSM LTE module must be installed
in the system.
Messaging is performed independently from reporting but reporting has the priority. If in the
course of messaging some events occur which must be reported to the monitoring station by
the control panel, the messaging will be interrupted. The control panel will resume the
messaging function after the event codes are reported to the monitoring station.
You can program the messaging:
• using the keypad, in the service mode, by means of the functions available in the
MESSAGING submenu,
You cannot use the keypad to configure the settings of SMS messaging via the
INT-GSM / INT-GSM LTE module.
• using the DLOADX program:
– in the “Messaging” window (voice and PAGER/SMS messaging),
– in the “Structure” window, “Hardware” tab, when configuring the module INT-GSM /
INT-GSM LTE settings (SMS messaging via the INT-GSM / INT-GSM LTE module).
For the messaging function to work properly, some system options may have to be enabled.
13.1 Messaging parameters and options
See also section “Telephone options” p. 71.
Shown in square brackets are the names used in keypads.
To Next Page
Loading...
