104 Programming SATEL
– IP format in which the codes will be sent (SATEL or SIA-IP),
– encryption key (STATION KEY) and control panel identifier for the purposes of reporting
via the cellular data network (GPRS KEY) if the SATEL format is selected,
– additional parameters if the SIA-IP format is selected,
– identifiers with which the events will be sent,
– event assignment (if STATION 1 AND 2 is selected),
– advanced options if SIA reporting format is selected.
4. If a reporting format other than CONTACT ID (FULL) or SIA (FULL) is selected:
– assign identifiers to the partitions, zones, keypads and expansion modules,
– program the codes for events which are to be reported.
5. Define the parameters of test transmissions.
12.2.4 SMS reporting
Reporting in case of INTEGRA 128-WRL control panel
Events in the SIA and TELIM formats cannot be sent as SMS messages.
1. Enable the SMS REPORTING option.
2. Determine whether the event codes will be sent to both monitoring stations or to one of
them only (STATION 1 OR 2 / STATION 1 / STATION 2 / STATION 1 AND 2).
3. Program the following for the monitoring station to which event codes are to be sent:
– reporting format in which the codes will be sent,
– telephone number to which the SMS messages will be sent,
– SMS message format,
– identifiers with which the events will be sent,
– event assignment (if STATION 1 AND 2 is selected),
4. If a transmission format other than CONTACT ID (FULL) is selected:
– assign identifiers to the partitions, zones, keypads and expansion modules,
– program the codes for events which are to be reported.
5. Define the parameters of test transmissions.
Reporting by using the INT-GSM / INT-GSM LTE module
The TELIM format events cannot be sent as SMS messages.
1. Enable the REPORTING – ETHM/INT-GSM option.
2. Determine whether the event codes will be sent to both monitoring stations or to one of
them only (STATION 1 OR 2 / STATION 1 / STATION 2 / STATION 1 AND 2).
3. Program the following for the monitoring station to which event codes are to be sent:
– reporting format in which the codes will be sent,
– server address (this address will not be used, but entering some character is required),
– identifiers with which the events will be sent,
– event assignment (if STATION 1 AND 2 is selected),
4. If a reporting format other than CONTACT ID (FULL) or SIA (FULL) is selected:
– assign identifiers to the partitions, zones, keypads and expansion modules,
– program the codes for events which are to be reported.
5. Define the parameters of test transmissions.
To Next Page
Loading...
