SATEL INTEGRA 85
Zone state [Zone characters]
You can define the symbols which will be used to illustrate the state of zones on the display.
Partition state [Part.characters]
You can define the symbols which will be used to illustrate the state of partitions on the
display.
Permanently displayed partitions [State part.]
You can select the partitions whose state will be permanently presented in the lower line of
the display. Up to 16 partitions can be selected. The partitions are displayed successively: for
example, if the partitions 3, 6 and 7 are selected, their state will be displayed in the first,
second and third position of the display.
8.1.4 User functions definition
Fig. 10. “User functions definition” tab for keypad in the DLOADX program.
Code+arrows – you can define which functions will be started on entering the code and
pressing the selected arrow key.
8.1.5 Proximity cards
Proximity card handling parameters are available for the keypads provided with proximity
card readers (INT-KLCDR and INT-KLFR).
Card function
Card read [Card close] – you can select the function executed after presenting the card.
Card holddown [Card close long] – you can select the function executed after holding the
card.
Door [Door to open] – if presenting the card or holding it is to open a door, you must indicate
the door supervised by the access control module or the 101. CARD READ – EXPANDER type
output.
Wrong card
Signal on wrong card [Unkn.card sig.] – if this option is enabled, reading in an unknown
card will be signaled by two long beeps.
To Next Page
Loading...
