110 Programming SATEL
SMS control – if this option is enabled, control by means of SMS messages is possible.
Tel. code required [Tel.cod.in SMS ] – if this option is enabled, the SMS message to be sent
to the control panel will have to contain, beside the control command, also the telephone
code.
Case sensitive – with this option enabled, the control panel will also analyze the received
control command for the proper use of uppercase and lowercase letters.
Confirm the control [Confirm by SMS ] – with this option enabled, execution of the control
will be confirmed by an SMS message sent to the telephone number from which the
message containing the control command was sent.
Accept only SMS from [Authorized tel.] – you can indicate the telephone numbers from the
list programmed for telephone messaging which will be authorized to send SMS messages
containing the control commands (the control commands sent from other telephone
numbers will be ignored by the control panel). If no telephone number is indicated, all the
telephone numbers will be authorized to send the control commands.
Service phone no. for SMS control [Service phone] – you can program an additional
telephone number authorized to send SMS messages containing the control commands.
When programming the control commands, remember that:
− the command can include from 4 to 16 alphanumeric characters,
− the command may not contain diacritic characters and/or spaces,
− the commands must be different (the same command must not be used for
controlling two zones, two functions, etc.),
− the content of one command may not be used as a whole when programming the
content of another command. For example, with the “zone1” and “zone11” type
commands, the control panel will be unable to execute the latter one.
Zone violation [SMS -> z.viol.]
SMS – the control command that can be sent in the SMS message to the control panel
telephone number in order to violate a zone (the zone will be violated after the SMS
message is received by the control panel). You can define up to 32 such control
commands and assign one zone to each of them.
Zone – the alarm system zone which is to be violated after the control panel receives an
SMS message with the control command. The zone need not to exist physically, but the
wiring type programmed for it must be different from NO DETECTOR or FOLLOW OUTPUT.
Starting the function [SMS -> function]
SMS – the control command that can be sent in the SMS message to the control panel
telephone number in order to run a function (the function will be started after the SMS
message is received by the control panel). You can define up to 8 such control commands
and assign one function to each of them.
Function – the function which is to be started after the control panel receives an SMS
message with the control command. You can select one of the following functions:
– arming in chosen mode,
– disarming,
– clearing alarm,
– zone bypassing (inhibiting),
– zone unbypassing,
– activating MONO SWITCH type outputs,
– activating BI SWITCH type outputs,
– deactivating BI SWITCH type outputs,
To Next Page
Loading...
