SATEL INTEGRA 29
opens the “Zones” window.
opens the “Outputs” window.
opens the “Timers” window.
opens the “Reporting” window.
opens the “Messaging” window.
opens the “Answering and remote control” window.
opens the “Service note” window.
opens the “Users” window.
opens the window with information on errors made when configuring the alarm
system
opens the “Data comparison” window.
reading/updating of data from the control panel.
data writing to the control panel.
opens the “Event log” window.
terminates the data reading/writing.
saves the time in the control panel, based on the computer clock.
writes data into the control panel FLASH memory.
displays a virtual keypad.
opens the drop-down menu, which makes available some tools to supervise the
system state.
opens the “Configuration” window, if the program does not communicate with the
control panel, or communicates with it through COM port or modem. Otherwise, the
current connection window will open.
Opening the “Configuration” window will close the COM port, which was
previously selected for communication. Closing the window will open the COM
port.
opens the drop-down menu, where you can select the method of establishing
communication between the program and the alarm control panel.
To Next Page
Loading...
