Satel Integra 64 - Page 65

SATEL INTEGRA 63
9. DAY ALARM – signals the following:
– alarms from 13. PANIC-SILENT type zones,
– medical alarms from the 14. MEDICAL - BUTTON and 15. PERSONAL EMERGENCY type
zones,
– alarms from 7. DAY/NIGHT type zones, if the partition to which the zone belongs is
disarmed,
– alarms from 8. EXTERIOR type zones, if the armed mode which assumes that the user
will stay inside the protected facility is enabled in the partition (see: USER MANUAL),
– alarms from 4. PERIMETER type zones, if the SIGNALING DELAY has been programmed for
them,
– alarm from 5. INSTANT and 6. EXIT type zones, if the BELL DELAY option has been
enabled and the SIGNALING DELAY has been programmed for them,
– alarms from zones, for which the REPORTING DELAY option has been enabled, provided
they were violated during the ENTRY DELAY countdown,
– unverified alarms, if the AUDIBLE ALARM AFTER VERIFICATION option is enabled for the
partition,
– the first violation of the 8.
EXTERIOR type zones when they are armed, provided the
S
URVEILLANCE TIME has been programmed for the zone,
– violation of the counting zones (16-31 type zones) when armed.
10. DURESS ALARM – action carried out under duress – signals that a DURESS type code
(or prefix) has been used in the system.
11. CHIME – signals violation of the zones when they are disarmed.
12. SILENT ALARM – activates in the same situations as the 9. DAY ALARM output. Additionally,
it can signal silent panic alarms.
13. TECHNICAL ALARM – signals alarms from zone types 40-56.
14. ZONE VIOLATION – indicates the violations of zones.
15. VIDEO ON DISARMED – controlled by zones with the VIDEO ON DISARMED option enabled.
16. VIDEO ON ARMED – controlled by zones with the VIDEO ON ARMED option enabled.
17. READY STATUS – indicates whether the system is ready for arming, i.e. whether there are
no violated zones (active when there is no violation).
18. BYPASS STATUS – indicates the bypassing of zones.
19. EXIT DELAY STATUS – indicates the EXIT DELAY countdown.
20. ENTRY DELAY STATUS – indicates the ENTRY DELAY countdown.
21. ARMED STATUS – indicates the armed status of partitions.
22. FULL ARMED STATUS – active if all selected partitions are armed.
23. ARM/DISARM BEEP – signals:
– starting the arming procedure (arming, if the exit delay has not been programmed) –
1 pulse,
– disarming – 2 pulses,
– clearing alarm – 4 pulses,
– denial of arming or arming procedure failure – 7 pulses.
The pulse duration is approx. 0.3 seconds.
24. MONO SWITCH – controlled by users, zones or timers. Using a code, zone violation or
turning timer on will activate the output for a preprogrammed time.
25. BI SWITCH – controlled by users, zones or timers. Depending on the current status, using
a code or violating a zone will activate/deactivate the output. Turning the timer ON
activates the output, and turning the timer OFF deactivates the output.