36
7.14 Settings: Set Trip Data
7.14 Set Trip Data
(GPS MAP → MAIN MENU → Settings → Set
Trip Data)
This is where you can control how inactive
routes are displayed, as well as the deletion/
preservation of trail and trip log data when a
new route is activated.
Showing Inactive Routes
• Use the joystick, moving left/right to toggle
between;
Show Inactive Routes: Inactive routes are
shown on maps.
Hide Inactive Routes: Inactive routes are
hidden on maps.
Show Inactive Routes SP: The start point
(SP) of each inactive route is shown on the
maps. (A gray marker with a black triangle
appears at the start point).
• Press Done or center press the joystick to
return to SETTINGS MENU.
Note: Showing inactive routes uses a lot
of operating memory on the unit, so it is
important to keep this selection to a minimum,
as it will slow down your unit. Showing too
many inactive routes could also 'freeze' your
unit. Only show a few short inactive routes,
or to reduce RAM consumption, choose the
Show Inactive Routes SP option.
Auto Clear Trail Data
• Use the joystick, moving left/right to toggle
between;
On: Trail data is cleared when a new route
is selected.
Off: Trail data is not cleared on new route
selection.
• Press Done or center press the joystick to
return to SETTINGS MENU.
Auto Reset Log
• Use the joystick, moving left/right to toggle
between;
Keep Log on New Route: Log will not be
cleared when starting a new route.
Clear Log on New Route: Log will be
cleared on starting a new route.
• Press Done or center press the joystick to
return to SETTINGS MENU
Pressing the Default button restores the
following settings:
Showing Inactive Routes
Show Inactive Routes SP
Auto Clear Trail Data
Off
Auto Reset Log
Keep Log on New Route
Figure 7.14
To Next Page
Loading...
