Scania AUS4 - Map View and POI Settings; Auto Zoom and POI Display Settings

83
In 3D mode the terrain is rendered with height/elevation-data included (3D
terrain) and the angle of the camera is adjusted to ground level.
- Auto zoom
If you set this option, the map scale is adjusted automatically by the navigation
system (increases and decreases) in order to ensure reliable navigation. You can
choose between far, normal, near and off. If you zoom manually the zoom will
switch back to auto zoom after 8 seconds automatically.
Note
POI symbols are shown depending on the displayed scale. Multiple POI
symbols can appear under a single symbol if there is a greatly reduced
zoom.
- POI icons
Use this menu to display and hide various points of interest, for example, petrol
stations, car parks or restaurants, with the appropriate symbols on map.
- 3D Landmarks
Use this checkbox to enable or disable 3D Landmarks on the map.
- 3D Cities
Use this checkbox to enable or disable 3D Cities on the map.
- Digital terrain model
Use this checkbox to enable or disable a digital terrain model on the map.
- Park areas
Use this checkbox to enable or disable park areas on the map.
- Railways
Use this checkbox to enable or disable railways on the map.
- City areas
Use this checkbox to enable or disable city areas on the map.
Route Guidance
The following settings/options are available under Route guidance:
- Voice guidance prompts
Use this option to adjust the degree of detail for voice guidance.
- Voice guidance volume
Use this option to change the volume of the voice prompts.
- Show turn-by-turn
Use this option to display the turn-by-turn symbol and written instruction during the
route guidance.
Traffic Safety
Traffic signs and traffic regulations always have priority over the driving
recommendations.