Schenck process Intecont Plus Belt Weigher - Block A: Dialog Behaviour (A06-A11)

Confirm: Access has to be confirmed again
for security reasons.
Note: The prefeeder also has to be activated with
parameter M01.
A06 Keyb. Mode ON/OFF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control access to the
basic functions of keyboard ON/OFF mode. The
range of values is identical to the A05 parameter.
A07 Batch ON/OFF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control access to the
basic functions of batch preselect/deselect. The
range of values is identical to the A05 parameter.
A08 >0: Zero ON/OF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control access to the
basic function of >0: zero setting. The range of
values is identical to the A05 parameter.
A09 EasyServe ON/OFF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control access to the
basic functions of EasyServe activate/deactivate.
The range of values is identical to the A05 parameter.
A10 Totalizer1 ON/OFF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control deleting counter
2. The range of values is identical to the A05
parameter.
A11 Totalizer2 ON/OFF
Range: active
not active
Password
2. Password
Confirm
Default: active
You can use this parameter to control deleting counter
2. The range of values is identical to the A05
parameter.
0837
VBW INTECONT PLUS
Parameterization
BV-H2214 GB 50
Technische
Redaktion PDE-RD
Transmission to third parties and reproduction of
this documentation are not permitted. Schenck
Process GmbH reserves all rights of ownership
and copyrights.