Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Socket wrench - T10545-
Note
The crankshaft must be removed to allow for removing the oil
spray jet for cylinder 4.
Removing
– Remove the noise insulation ⇒ chassis installation work, ex‐
terior; Rep. gr. 66 ; Noise silencer; installation overview - noise
insulation .
– Remove upper section of sump ⇒ page 208 .
– Turn crankshaft via vibration damper securing bolt in direction
of engine rotation until the respective bolt is accessible.
– Unscrew pressure relief valve -1- using bit - T10545- .
– Remove oil spray jets -2-.
Fitting
CAUTION
Risk of damage to oil spray jets caused by deformation.
– Do not bend oil spray jets.
• The side wall of the oil spray jet -1- must be parallel to the
crankshaft bearing -2-.
• Distance -a- = distance -a-.
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
5. Pistons and conrods 103
To Next Page
