Seat Ateca 2017 - Removing and Installing Gearbox Mounting

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
2.3 Removing and installing gearbox
mounting
Special tools and workshop equipment required
♦ Torque wrenches - V.A.G 1331-
♦ Torque wrenches - V.A.G 1332-
♦ Engine support - T50015A-
♦ Supports of the positioner - T10533/2-
♦ Bolt M12 x 20 mm of the positioner - T10533/4-
Removing
Vehicles with all-wheel drive
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Assembly overview - noise in‐
sulation .
– Remove pendulum support ⇒ page 50 .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
2. Assembly bracket 47