Seat Ateca 2017 - Removing and Installing Oil Pressure Switch for Reduced Oil Pressure F378

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
4.5 Removing and installing oil pressure
switch for reduced oil pressure - F378-
Special tools and workshop equipment required
♦ 24 mm jointed spanner - T40175-
Removing
Vehicles with auxiliary radiator (left-side):
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
Continued for all vehicles
Note
♦ Place a cloth underneath bracket for ancillaries to catch any
escaping oil.
♦ Since the seal cannot be renewed individually, the oil pressure
switch needs to be renewed following removal.
– Unplug electrical connector -arrow- at oil pressure switch for
reduced oil pressure - F378- .
– Unscrew oil pressure switch for reduced oil pressure -1-.
Fitting
Installation is carried out in the reverse order; note the following:
Note
♦ Renew seal.
♦ Fit the new oil pressure switch for reduced oil pressure - F378-
into the connection immediately to avoid loss of oil.
– Install the windscreen washer tank filler ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling windscreen washer tank .
– Check oil level ⇒ page 203 .
Specified torques
♦ ⇒ “4.2 Exploded view - oil pressure switches/oil pressure con‐
trol”, page 222
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
4. Oil filter/oil pressure switches 225