Seat Ateca 2017 - Removing and Installing Engine; Removing and Installing the Engine; Engine Removal

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
10 – Removing and installing engine
1 Removing and installing the engine
⇒ “1.1 Engine removal”, page 11
⇒ “1.2 Separating engine and gearbox”, page 29
⇒ “1.4 Securing engine to engine and gearbox support”,
page 37
⇒ “1.5 Installing engine”, page 39
1.1 Engine removal
Special tools and workshop equipment required
♦ Hydraulic column jack - VAS 6931-
♦ Support bridge - T10323- for vehicles with all-wheel drive
♦ Engine bracket - T10359 A-
♦ Pins - T10359/2-
♦ Adapters - T10359/3-
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
1. Removing and installing the engine 11