Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Check coolant level.
• When the engine is at operating temperature, the coolant level
must be at the »weld seam« -arrow-.
• When the engine is cold, the coolant level must be approx.
5 mm above the max. mark -arrow-.
Note
This excessive amount of coolant level is necessary since the
coolant level may decrease automatically due to bleeding proc‐
ess.
1.3 Checking cooling system for leaks
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
244 Rep. gr.19 - Cooling
To Next Page
