Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Lambda probe connectors
1 - Connector for Lambda probe 1 after catalytic converter - GX7-
2 - Electrical connector from the Lambda probe 1 before catalytic
converter - GX10-
8.2 Removing and installing Lambda probe
⇒ “8.2.1 Removing and installing Lambda probe 1 before catalytic
converter GX10 ”, page 388
⇒ “8.2.2 Removing and installing Lambda probe 1 after catalytic
converter GX7 ”, page 389
8.2.1 Removing and installing Lambda probe
1 before catalytic converter - GX10-
Lambda probe 1 before catalytic converter - GX10- comprises:
♦ Lambda sensor - G39-
♦ Lambda probe heater - Z19-
Special tools and workshop equipment required
♦ Lambda probe open ring spanner set - 3337-
♦ Torque wrench - V.A.G 1332-
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
388 Rep. gr.24 - Mixture preparation - injection
To Next Page
