Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
– Remove engine cover panel ⇒ page 57 .
– Unclip right mounting -1- for engine cover panel from retainer
-2-.
Vehicles with windscreen washer tank, right side
– Remove windscreen washer tank filler -2- ⇒ Electrical system;
Rep. gr. 92 ; Windscreen washer system; Removing and in‐
stalling tank for windscreen washer system .
Continued for all vehicles
– Disconnect electrical connector -1-.
– Free hoses -2- from fittings and lay them to one side.
– Release catches in direction of -arrow- with a screwdriver and
move coolant expansion tank to one side.
– Bracing the engine in its installation position ⇒ page 51
– Remove bolts -arrows- and detach engine mounting -1-.
Installation
Install in the reverse order of removal, observing the following:
Note
♦
Renew the bolts tightened with specified tightening angle.
♦
The engine and gearbox mounting must be set optimally in
order to avoid vibrations.
– Check adjustment of assembly mountings (engine/gearbox
mountings) ⇒ page 56 .
Specified torques
♦ ⇒ “2.1 Installation overview - assembly mountings”, page 44
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
46 Rep. gr.10 - Removing and installing engine
To Next Page
