Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Cable support bracket - T10355-
♦ Engine bung set - VAS 6122-
♦ Sealant ⇒ Electronic parts catalogue (ETKA)
Removing
Note
♦
Sealing surfaces at bottom of cylinder head cover and top of
cylinder head must not be machined.
♦
The camshaft bearings are integrated into the cylinder head
and cylinder head cover. The camshaft timing chain must be
relieved of tension before you remove the cylinder head cover.
♦
Fit the cable ties in the original position when installing.
– Remove air filter housing ⇒ page 356 .
– Remove upper coolant pipe ⇒ page 289 .
– Remove ignition coils ⇒ page 452 .
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. gr. 66 ; Noise insulation; Removing and installing noise
insulation .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
160 Rep. gr.15 - Cylinder head, valve gear
To Next Page
