Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
Removing
– Remove the poly V-belt ⇒ page 60 .
– Place the used oil collection and extraction unit - VAS 6622A-
below engine.
– Unplug electrical connector -1-.
– Remove bolt -2- and detach valve for oil pressure control -
N428- -3-.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew O-ring.
Specified torques
♦ ⇒ “4.2 Exploded view - oil pressure switches/oil pressure con‐
trol”, page 222
♦ Assembly overview - noise insulation ⇒ General body repairs,
exterior; Rep. gr. 66 ; Noise insulation; Assembly overview -
noise insulation .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
232 Rep. gr.17 - Lubrication
To Next Page
