Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
– Disconnect connector -4-, and pull out retaining clip -3-.
– Pull out radiator outlet coolant temperature sender - G83- -1-
with O-ring -2-.
Note
♦
Place a cloth underneath to catch escaping coolant.
♦
Insert new coolant temperature sender - G83- immediately in‐
to screw connection at radiator outlet to avoid loss of coolant.
Fitting
Install in the reverse order of removal, observing the following:
Note
Renew O-ring.
– Check coolant level ⇒ page 240 .
Specified torques
♦ Assembly overview - noise insulation ⇒ General body repairs,
exterior; Rep. gr. 66 ; Noise insulation; Assembly overview -
noise insulation .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
286 Rep. gr.19 - Cooling
To Next Page
Loading...
