Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by SEAT S.A. SEAT S.A does not guarantee or accept any liability with
respect to the correctness of information in this document. Copyright by SEAT S.A.
♦ Drift - VW 207 C-
Requirement:
• The front edges of the internal puller must not be chipped.
• Gearbox has been removed.
Pulling out needle roller bearing
– Pull out needle bearing -1- with internal puller - VAS 251 635-
-A- and counter support, e.g. KUKKO 22-1 - VAS 251 621-
-B- from crankshaft -2-.
– The internal puller must be positioned behind the needle roller
and cage assembly -arrow-.
Fitting
– Clean bearing seat in crankshaft and grease lightly.
– Drive needle bearing into crankshaft to installation depth using
drift - VW 207 C- .
Ateca 2017 ➤ , León 2013 ➤ , León ST 2013 ➤
4 cyl. petrol engine (1.8 l and 2.0 l with direct injection, 4 V, exhaust gas turbocharger, timing chain,
EA 888 III. Gen) - Edition 10.2018
3. Crankshaft 83
To Next Page
Loading...
