EasyManua.ls Logo

Sel 551 - Appendix A: Firmware and Manual Versions Firmware

Sel 551
268 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
A.2
SEL-551 Relay Instruction Manual Date Code 20110408
Firmware and Manual Versions
Firmware
SEL-551-R111-Vr-Z001001-D20061005
SEL-551-R511-Vf-Z002002-D20061005
➤ Modified front-panel phase targeting to target on other 50/51
fault elements.
➤ Fixed the demand ammeter calculation during the transition of
daylight savings when connected to a timesource.
➤ Added relay settings to the end of the compressed event reports.
20061005
SEL-551-R110-Vr-Z001001-D20050523
SEL-551-R510-Vf-Z002002-D20050523
➤ Manual update only (see Table A.2). 20050725
SEL-551-R110-Vr-Z001001-D20050523
SEL-551-R510-Vf-Z002002-D20050523
➤ Fixed Modbus
®
communications issue when polled by certain
Modbus master devices.
20050523
SEL-551-R509-Vf-Z002002-D20050124
➤ Password security enhancement.
➤ Rising-edge and falling-edge detect operators in SELOGIC
®
control equations.
➤ Torque control setting equations for overcurrent elements can no
longer be set directly to logical 0.
➤ Relay Word bit TRGTR (Target Reset output).
➤ VER serial port command.
20050124
SEL-551-R109-Vr-Z001001-D20030905
SEL-551-R508-Vf-Z001001-D20030905
➤ CT Saturation Protection was enhanced to improve security
with low-set instantaneous values.
20030905
SEL-551-R108-Vr-Z001001-D20020828
SEL-551-R507-Vf-Z001001-D20020828
➤ Manual update only (see Table A.2). 20021025
SEL-551-R108-Vr-Z001001-D20020828
SEL-551-R507-Vf-Z001001-D20020828
➤ Added CT Saturation Protection
➤ Added Raw Event Report
➤ Made internal changes to support battery-backed clock hard-
ware change.
20020828
SEL-551-R107-Vr-Z001001-D20000211
SEL-551-R506-Vf-Z001001-D20000211
➤ Manual update only (see Table A.2). 20010518
SEL-551-R107-Vr-Z001001-D20000211
SEL-551-R506-Vf-Z001001-D20000211
➤ Added Modbus
®
RTU protocol.
➤ Added instantaneous element front-panel targeting of INST, A, B,
C, and N LEDs.
➤ Changed FID format.
20000211
SEL-551-R106-Vr-D991116
SEL-551-R505-Vf-D991112
➤ Manual update only (see Table A.2). 991117
SEL-551-R106-Vr-D991116
SEL-551-R505-Vf-D991112
➤ Improved Fast Operate compatibility. 991112
SEL-551-R105-Vr-D970616
SEL-551-R504-Vf-D970616
➤ Manual update only (see Table A.2). 981201
SEL-551-R105-Vr-D970616
SEL-551-R504-Vf-D970616
➤ Manual update only (see Table A.2). 981027
SEL-551-R105-Vr-D970616
SEL-551-R504-Vf-D970616
➤ Manual update only (see Table A.2). 980831
SEL-551-R105-Vr-D970616
SEL-551-R504-Vf-D970616
➤ Manual update only (see Table A.2). 970717
SEL-551-R105-Vr-D970616
SEL-551-R504-Vf-D970616
Added Demand Ammetering:
See Demand Ammetering toward end of Section 3: Relay Elements
and Logic.
970616
➤ Added settings DMTC, PDEMP, NDEMP, GDEMP, QDEMP
(see Settings Sheet page 3, Section 4: Setting the Relay).
➤ Added Relay Word bits PDEM, NDEM, GDEM, QDEM (see
Table 4.3 and Table 5.5).
Table A.1 Firmware Revision History (Sheet 2 of 3)
Firmware Identification (FID) Number Summary of Revisions
Manual
Date Code

Table of Contents