Sel 551 - Rotating Default Display

6.11
Date Code 20110408 Instruction Manual SEL-551 Relay
Front-Panel Interface
Rotating Default Display
Rotating Default Display
The relay name, SEL-551, displays if no local control is operational (i.e., no
corresponding switch position label settings were made) and no display point
labels are enabled for display.
The
Press CNTRL for Local Control message displays if at least one local
control switch is operational. It is a reminder of how to access the local control
function. See the preceding discussion in this section and Local Control
Switches on page 3.5 for more information on local control.
If display point labels are also enabled for display, the
Press CNTRL for
Local Control
displays for two seconds and then is followed by enabled
display point labels in subsequent two-second rotations.
SCHWEITZER ENGINEE
PULLMAN WASHINGTON USA
FAULT TYPE
A
INSTEN BCNRSLO
79
SEL-551
SCHWEITZER ENGINEE
PULLMAN WASHINGTON USA
FAULT TYPE
A
INSTEN BCNRSLO
79
Press CNTRL for
Local Control