Sharp UP-3500 - Employee Function

115
Employee Function
You can use the following functions by using employee codes:
Clerks or managers can be signed on by entering employee codes, or they can be signed on by using
employee cards. To use an employee card, you need a magnetic card reader (MCR). Contact your
authorized SHARP dealer.
Use the following procedures:
••
••
• Clerk sign-on
XXXX (Secret code)
Reading an employee card
[EMPL#]
Employee code (max. 10 digits)
[EMPL#]
[ENTER]
[ENTER]
Employee code (max. 10 digits)
[EMPL#]
In the case of “Contact-less clerk key system,” sign-on cannot be done by this procedure.
••
••
• Manager sign-on
XXXX (Secret code)
Reading an employee card
[EMPL#]
Employee code (max. 10 digits)
[EMPL#]
[ENTER]
[ENTER]
Employee code (max. 10 digits)
[EMPL#]