Sharp UP-3500 - Non-Accessed EAN and Customer Deletion

191
Non-accessed EAN and Customer Deletion
You can delete EANs and customers that had not been accessed for a certain period. You can program a
period
in the PGM2 mode. As for customer, you can also delete customers with regardless to a non-accessed
period.
Follow the procedure shown below.
••
••
• Non-accessed EAN deletion
1. Select the X1/Z1 mode.
2. Select “NON ACCESSED EAN”.
3. To take a reading report, select “READING”.
To delete non-accessed EANs, select “DELETE”. The selection window “ALL DELETE/IND.DELETE” is
displayed.
To delete all the non-accessed EANs, select “ALL DELETE”.
To delete the non-accessed EANs individually, select “IND.DELETE”.
4. To terminate the operation, touch the [EXIT] button.
It is recommended to take a report first before executing deleting operation.
••
••
• Non-accessed customer deletion
1. Select the X2/Z2 mode.
2. Select “NON ACCESSED CUST.”.
3. To take a reading report, select “READING”.
To delete non-accessed customers, select “DELETE”. The selection window “ALL DELETE/
IND.DELETE” is displayed.
To delete all the non-accessed customers, select “ALL DELETE”.
To delete the non-accessed customers individually, select “IND.DELETE”.
4. To terminate the operation, touch the [EXIT] button.
It is recommended to take a report first before executing deleting operation.
••
••
• Customer deletion
1. Select the X2/Z2 mode.
2. Select “CUSTOMER DELETE”.
3. Specify the range (start/end customer codes) you want to delete.