Sharp UP-3500

200
How to Program Alphanumeric Characters
When you program alphanumeric characters, the character keyboard will be displayed as shown below.
[TEXTCOPY] : Used to copy the text data.
[PASTE] : Used to paste the text data.
[TEXT_START] : Used to skip to the start of a text.
[TEXT_END] : Used to skip to the end of a text.
[CANCEL] : Used to cancel programming and to get back to the previous screen.
[OK] : Used to finalize programming.
[NORMAL/DOUBLE] : Used to change the normal size or double size.
[INS] : Used to switch the insert/over-write mode.
[DELETE] : Used to delete the character or figure at the cursor position.
[BACK_SPACE] : Backs up the cursor for deleting the character or figure at the left of the cursor.
[ ] : Used to control the cursor (left)
[ ] : Used to control the cursor (right)
[ ] : Used to control the cursor (down)
[ ] : Used to control the cursor (up)
[SHIFT] : You can enter an upper-case letter by using this key. Touch this key just before you
enter the upper-case letter. You should touch this key each time you enter an
upper-case letter.
[LIST] : Used to change the page of characters.
[CAPS] : Used to enter the capital-letters lock mode.
[ENTER] : Used to start a new line.
▲
▲
▲
▲