Sharp UP-3500

25
Clerk Assignment (Sign-on/Sign-off)
■■
■■
■ Clerk assignment
Prior to any item entries, a clerk must enter his/her clerk codes into the POS terminal. On your POS
terminal, You can use any of the following procedures to assign your clerk code.
••
••
• Contact-less clerk key
This type allows clerks to be assigned by setting corresponding contact-less clerk keys.
* The contact-less clerk key is optional.
••
••
• Clerk code entry system
If you select this type, clerks can be assigned by entering his or her clerk code with the [CLK#] key in
advance.
••
••
• Clerk entry key system
If you select this type, clerks can be assigned by touching corresponding clerk keys ([CLK n]) on the
keyboard.
••
••
• Clerk card entry system
This type allows clerks to be assigned by scanning the clerk card.
* The card reader is optional.
<Sign on operation>
1) Clerk code (max. 4 digits) ➝ [CLK#] (Sign On) / or touching the [CLK n] key / or setting the contact-less
clerk key
2) Entering the password (if required)
3) Entering the drawer number (if required)