283
■■
■■
■ On-line (DEVICE CONFIG
➝
ONLINE ....... PGM2)
(1) Select the PGM2 mode and touch the [SETTING] to perform the programming.
(2) Touch the [DEVICE CONFIG] button to display the menu, and touch the [ONLINE] button to program
details.
(3) Select the required programming item, and enter or select each parameter, then touch the [ENTER]
key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text Parameter
CHANNEL# 0 - 5: “0”means no RS-232 channel is assigned.
■■
■■
■ Pole display
(DEVICE CONFIG
➝
POLE DISPLAY ....... PGM2)
(1) Select the PGM2 mode and touch the [SETTING] to perform the programming.
(2) Touch the [DEVICE CONFIG] button to display the menu, and touch the [POLE DISPLAY] button to
program details.
(3) Select the required programming item, and enter or select each parameter, then touch the [ENTER]
key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text Parameter
WAITING TIME
Waiting time until the message is displayed on the pole display (0 to 999seconds)
When you program as “0”, no message is displayed.
To Next Page
Loading...
