Sharp UP-3500 - On-Line Configuration Programming

289
■■
■■
■ On-line configuration programming (ONLINE CONFIG ....... PGM2)
(1) Select the PGM2 mode and touch the [SETTING] to perform the programming.
(2) Touch the [ONLINE CONFIG] button to program details.
(3) Touch the required programming item, and enter or select each parameter and touch the [ENTER] key.
Repeat this step (3) satisfactorily.
(4) To terminate the programming, touch the [EXIT] key.
Text Parameter
TERMINAL No. 6 digits ((0 to 999999) : 000001)
CI SIGNAL
SENSING: Sensing of the CI signal
NON: Non sensing of the CI signal
Transmission line form;
LINE FORM HALF: Half duplex system
FULL: Full duplex system
Transmission data rate (Baud rate)
115200 bps
57600 bps
BAUD RATE
38400 bps
19200 bps
9600 bps
4800 bps
2400 bps
START CODE Start code: 3 digits ((0 to 127) : 002)
END CODE End code: 3 digits ((0 to 127) : 013)
TIME OUT Time out time: 3 digits ((1 to 255 (sec)) : 007)
AT OPEN STORE At command with open store: max. 50 characters (null)
AT CLOSE STORE At command with close store: max. 50 characters (null)