Sharp UP-3500

39
■■
■■
■ Scale entries
This function is used to sell items by weight. There are two types of weight entry systems available; auto
scale entries and manual scale entries. Auto scale entry is used when the weight is read automatically from
the connected scale (option).
In the case of manual scale entry, the weight is entered by using the ten key pad function.
••
••
• Auto scale entries
Open tare weight entry:
➝
[OPEN_TARE]
➝
Tare weight
➝
[SCALE]
➝
(Single item entry)
Tare table number entry:
➝
Tare table number
➝
[SCALE]
➝
(Single item entry)
• Open tare weight: Up to 5 digits (integer + decimal)
• Scale table number: 1 to 9
• Net weight: Up to 5 digits (integer + decimal)
• When you use a programmed tare table number, skip the tare table no. entry (
➝
Tare table number ).
• When the item is programmed for “compulsory scale entry”, it is not necessary to touch the [SCALE] key.
• To issue a receipt which shows only a tare weight (Issuing the Tare receipt):
➝
[OPEN_TARE]
➝
Tare weight
➝
[SCALE]
➝
[CASH_TOTAL]
• The currency descriptor is displayed/printed when it is programmed for the CHECK.
Key Operation Display
2 [SCALE] 650 [Department 6 ]
3 [SCALE] 1 [PLU_EAN]
[CASH_TOTAL]
••
••
• Manual scale item entry
➝
Net weight
➝
[SCALE]
➝
(Single item entry)
• Gross weight: Up to 5 digits (integer + decimal)
• The net weight is automatically calculated using the programmed tare weight.
• The currency descriptor is displayed/printed when it is programmed for the CHECK.