Sharp UP-3500

334
Drink Dispenser
Your POS terminal can be connected with a drink dispenser.
The drink dispenser is exclusively connected to the POS terminal via an ISB-box and never directly.
The connection is made via a free and available RS232C Com Port.
Per POS terminal maximally one ISB-box can be connected.
Within a network one ISB-box can be connected to each POS terminal. The connection to the drink
dispenser consists of constant communication, the so-called polling.
When an entry error is found, perform the following steps:
1. Check the error by the drink dispenser misoperation file reading or drink dispenser error reading.
Drink dispenser misoperation file reading REG or MGR mode
Clerk report OP X/Z or X1/Z1 mode
If there is misoperation data when you take an individual or full clerk X/Z report, the machine
waits for selection of one of the following three commands (RETRY, ABORT and IGNORE)
before the report is issued.
1 RETRY: attempts to retry the report issuing job.
2 ABORT: cancels the report issuing job.
3 IGNORE: issues the report, disregarding that there is misoperation data. In the case of
the Z report, misoperation data is also reset.
Drink dispenser error reading X1/Z1 mode
2. Correct the error with the drink dispenser correction in the REG or MGR mode.
The error which relates to GLU codes can be corrected. However, the error which relates to PLU codes or
clerk codes cannot be corrected with the drink dispenser correction.
Procedure to return from Off-line to On-line mode
Case 1:
The drink dispenser was set to Off-line only for a short term and there have been no change in GLU
occupations (same guests at the same table).
The data-buffer of the drink dispenser can be emptied by using the DD reset function (Z1 mode). The POS
terminal - drink dispenser line is automatically set to On-line by this function.
Case 2:
The drink dispenser was set to Off-line for a long term. Therefore, the use of the DD reset function is not
applicable because GLU occupations have been changed, meanwhile. Empty the drink dispenser data
buffer at the drink dispenser directly and set the POS terminal - drink dispenser line to On-line manually.
14
▲ ▲ ▲
The data such as GLU codes, clerk codes,
sort numbers and so on which are entered at
a drink dispenser is sent to the POS terminal.
Drink Dispenser UP-3500
▲