Figure 90: Opening MainRoutine
If the process flow for writing a preset value is to run parallel to the previous
example, then a new string must be inserted.
Figure 91: Inserting Rung block
2. From the Favorites tab, select the Rung block and insert it into the MainRoutine .
The first block to be inserted is an input that is to trigger the “Set preset value"
process.
Figure 92: Inserting ExamineOn module
3. From the Favorites tab, select the ExamineOn block and insert it into the MainRoutine .
The corresponding variable must be assigned to this input, in our example variable
PRESET_Trigger.
CONFIGURATION USING A PLC 5
8014213/1EF3/2021-12-08 | SICK O P E R A T I N G I N S T R U C T I O N S | AFS/AFM60 EtherNet/IP
87
Subject to change without notice
To Next Page
Loading...
