Operating instructions Chapter 2
Flexi Classic
8011509/YPP0/2015-10-26 © SICK AG • Industrial Safety Systems • Germany • All rights reserved 13
Subject to change without notice
On safety
The Flexi Classic system complies, as per the “radiated emissions” generic standard,
with the requirements of class A (industrial applications).
The Flexi Classic system is therefore only suitable for use in an industrial environment.
Loss of the safety function through an incorrect configuration!
Plan and carry out configuration carefully!
The configuration of safety applications must be carried out with the greatest accuracy and
must match the status and the condition of the machine or system to be monitored.
= Check whether the configured safety application monitors the machine or system as
planned and whether the safety of a configured application is ensured at all times. This
must be ensured in each operating mode and partial application. Document the result
of this check!
= In each case, observe the instructions for commissioning and daily checking in the
operating instructions of the protective devices integrated into the safety application!
= Note the warnings and function descriptions of protective devices connected to the
safety controller! Contact the respective manufacturer of the protective device if in
doubt!
WARNING
WARNING
To Next Page
Loading...
Need help?
General
