864-5091.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DB10 • Revision 06 133/214
Installation
31 Installation of degree of protection version IP31D
31.1 IP31D - protection against vertically falling water drops
Mounting protection
plates (if not pre-
assembled at the factory)
➭ On the roof plates of the panels, the sealing tape was pre-assembled at the factory.
➭ Mount protection plates for intermediate and end panels. To do this, use bolts M6 x 25.
Fig. 145: Overview: Degree of protection version IP31 for panels
①
Protection plate for left end panel
②
Sealing strip for intermediate panels
③
Protection plate for intermediate panels
④
Protection plate for right end panel
⑤
Sealing tape between the individual
panels, and between roof plate and
protection plate
Fig. 146: Example: Fastening protection plate for end panel and intermediate panel
①
Protection plate for left end panels
(6 bolts M6 x 25)
②
Protection plate for intermediate
panels (6 bolts M6 x 25)
③
Sealing tape
To Next Page
Loading...
