Siemens 8DB10 - Operation; Control elements and indicators

Operation
146/214 Revision 06 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DB10 • 864-5091.9
Operation
35 Control elements and indicators
Overview
DANGER
The internal arc classification of the switchgear according to IEC 62271-200 has only been
proved by tests for the switchgear sides with internal arc classification and with closed
high-voltage compartments.
➭ Determine the IAC classification of the switchgear by means of the data on the rating plate
(see page 48, "Rating plates").
➭ Regulations for access to switchgear areas without internal arc classification according to
IEC 62271-200 must be defined by the entrepreneur or the switchgear operator.
Fig. 164: Switchgear front
①
Manometers of the SF
6
gas compartments for busbars L1, L2, L3 of
busbar system 1
②
Manometers of the SF
6
gas compartments for busbars L1, L2, L3 of
busbar system 2
③
Gas filling valve
④
"ON" pushbutton (mechanical), sealable and lockable by the customer
⑤
"OFF" pushbutton (mechanical), sealable and lockable by the customer
⑥
Locking device
⑦
Sockets for voltage detecting system
⑧
Counter for operating cycles
⑨
Position indicator for circuit-breaker "CLOSED"/"OPEN"
⑩
"Closing spring charged / not charged" indicator
⑪
Opening for hand crank for charging the circuit-breaker closing spring
⑫
Selector gate for busbar system
⑬
Control and indication board for three-position disconnector operating
mechanism
⑭
Gas filling valve
⑮
Manometer for three-position disconnector housing in busbar system 1
⑯
Manometer for circuit-breaker housing
⑰
Manometer for three-position disconnector housing in busbar system 2
⑱
Low-voltage compartment