AddFEM
Technical Data
4-29
AddFEM
C79000–G8076–C900–03
Information in the Diagnostic Message (continued):
PROM_F INT Check sum program code in the FLASH–EPROM invalidated
KORRDAT_F INT Check sum correction factors in the FLASH–EPROM invalidated
1)
The failure of the redundancy partner is signaled at the operating mode with redundant PROFIBUS DP
2)
The diagnostic message is removed in the key switch position RUN (going diagnosis).
3)
The diagnostic message is removed in the slide switch position 1 Rest (going diagnosis).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
