Siemens Add 7 AddFEM - Setting the PROFIBUS-DP Address for Bus B Via Key-Operated and Slide Switches

Commissioning / Operation / Maintenance AddFEM
5-12
AddFEM
C79000–G8076–C900–03
Seq.
No.
Next step,
if ...
Display/ReactionHandling
(key–operated and
slide switches)
Operation
6 Set the regular
”RUN” mode again.
Turn the key–opera-
ted switch to ”RUN”
or ”RUN P”.
RUN P
MRES
RUN
STOP
Setting has
been com-
pleted.
5.2.2 Setting the PROFIBUS–DP Address for Bus B via Key–operated
and Slide Switches
The following section describes the procedure step–by–step to be carried out when
setting the PROFIBUS DP address for Bus B (connector X3B at AddFEM) by the
maintenance/repair personnel with the operating elements of the AddFEM (key–
operated and slide switches).
Notice
The procedure corresponds essentially to the procedure for setting the PROFIBUS
DP address for Bus A. However, the operating mode Function Mode 2, “Set DP
Address B” has to be set at Step 2 by pressing the slide switch 2 once more!
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com