Operation
6.2 Upload and download of parameter sets
Control Units CU240S
6-2 Operating Instructions, 11/2006, A5E00766042B AA
6.2 Upload and download of parameter sets
Upload of parameter sets
With an upload, a parameter set can be saved in one of the following devices:
● PC (via STARTER)
● MMC
● OP
Note
The file format for the MMC is FAT. Any other format, such as FAT32 or NTFS are not
compatible with uploading and downloading parameter sets from the inverter.
Formatting can be accomplished using the DOS command line as follows:
C:\>format volume /FS:FAT - where volume has to be replaced by the name of the MMC
drive, for example A.
Please keep in mind that formatting will delete all the contents of the MMC.
An upload can be triggered via
● PROFIBUS
● OP
● STARTER
A detailed description is given in "Series Commissioning" in the commissioning section.
Download of parameter sets
In the case of a parameter download it is important to distinguish between the following
possibilities:
● Manual download
● Automatic download.
To Next Page
Loading...
Need help?
General
