Siemens CU240S DP-F User Manual

Commissioning (software)
5.2 Parameters
Control Units CU240S
5-2 Operating Instructions, 11/2006, A5E00766042B AA
5.2 Parameters
Overview of parameters
The inverter is adapted to a particular application using the appropriate parameters. This
means that each parameter is identified by a parameter number and specific attributes (e.g.
readable, can be written into BICO attribute, group attribute etc.). Within any one particular
inverter system, the parameter number is unique. On the other hand, an attribute can be
assigned a number of times so that several parameters can have the same attribute.
Parameters can be accessed using the following operator units:
● OP
● PC-based commissioning (start-up) tool "STARTER".
There are two main types of parameters; those that can be altered and those that are read-
only.
3DUDPHWHU
5HDGU
ಯQRUPDOರ
5HDGSDUDPHWHUV
ಯQRUPDOರ
:ULWH5HDGSDUDPHWHUV
%,&2RXWSXW %,&2LQWSXW
:ULWH5HDG3
Figure 5-1 Parameter types

Siemens CU240S DP-F Specifications

General

Brand	Siemens
Model	CU240S DP-F
Category	Control Unit
Language	English