Control Units CU240S
Operating Instructions, 11/2006, A5E00766042B AA
Index-1
Index
2
2-wire control, 8-41, 8-42
3
3-wire control, 8-41
A
Acceptance test, 5-75
Accessories
Multi Media Card (MMC), 10-1
Operator Panel (OP), 10-1
PC Connection Kit, 10-1
Screen Termination Kit, 10-2
Alarm messages, 7-3
Analog inputs, 8-18
Analog outputs, 8-20
B
BICO parameterization, 8-15
BICO technology, 8-3
Binector Connector Technology, 8-3
blackout, 8-93
brownout, 8-93
Bus terminator, 4-14
C
Calculating the motor/control data, 5-29
Changing parameters with the Operator Panel, 5-14
Chip temperature, 8-158
Classification of EMC performance, A-2
Closed-loop control, 8-160
Closed-loop torque control, 8-180
Closed-loop Vdc control, 8-138
Commissioning, 5-108
Commissioning functions, 3-3
Commissioning the application, 5-31
Common features, 3-3
Compound braking, 8-86
Configuration with SIMATIC S7, 4-10
Control functions, 3-4
Control Wiring, 4-5
Control word, 5-87
Conversion of extended PROFIBUS DP
functionality, 5-93
Current limiting, 8-168, 8-184
D
Data sets, 8-6
DC braking, 8-82
DC link overvoltage, 8-138
DC link undervoltage, 8-138
Device-specific telegrams, 5-83
Digital inputs, 8-13
Fixed frequencies, 8-37
Digital outputs, 8-16
Download parameters, 5-47, 5-48
Droop, 8-179
Dynamic braking, 8-88
E
Electromagnetic compatibility, A-1
Electronic brakes, 8-82
EMC precautions, 4-15
EMC Standards, A-1
European EMC Directive, A-6
European Low Voltage Directive, A-6
European Machinery Directive, A-6
Extended configuration for the SINAMICS G120, 5-82
Extended PROFIBUS DP functionality, 5-92
F
Factory setting, 5-10
Reset to, 5-60
Fault messages, 7-3
Fitting the Control Unit to the Power Module, 4-2
Fixed frequencies, 8-37
Flying restart, 8-96
Flying restart with speed encoder, 8-98
To Next Page
Loading...
