Index
Control Units CU240S
Index-2 Operating Instructions, 11/2006, A5E00766042B AA
Flying restart without speed encoder, 8-97
Forced dynamisation, 8-102
Free function blocks, 8-69
G
General I/O DIP switches, 3-13
H
Heatsink temperature, 8-158
I
I/O DIP switch, 8-18
i2t monitoring, 8-158
Imax controller, 8-168
Inputs and outputs, 8-13
Installation of PROFIBUS DP, 4-11
Installing a G120 GSD file, 5-99
ISO 9001, A-6
J
JOG, 8-50
K
Kinetic buffering, 8-141
KTY84 temperature sensor, 8-156
L
Limiting the torque setpoint, 8-183
Line failure, 8-93
Line undervoltage, 8-93
Load torque monitoring, 8-147
M
Manufacturer-specific telegrams, 5-83
Maximum cable lengths, 4-12
MMC
Manual download, 5-54
Upload, 5-53, 6-7
Modification - frequency setpoint, 8-59
Monitoring functions / messages, 8-145
Monitoring parameters, 5-3
Monitoring the fail-safe functions, 8-101
Motor data identification, 5-26
Motor holding brake, 8-78
Motorized potentiometer, 8-48
N
Normal Status LEDs, 7-6
O
OP, 5-46, 5-47, 5-53
Open-loop control, 8-160
Operating functions, 3-4
Options for SINAMICS G120, 3-2
Overload responses, 8-150, 8-158
P
Parameter
upload, 6-2
Parameters
Access level, 5-5
Active, 5-8
Atrributes, 5-4
BICO, 5-5
Change state, 5-6
Data sets, 5-9
Data types, 5-6
Grouping, 5-8
Quick commissioning, 5-9
Unit, 5-7
Value range, 5-9
PID controller, 8-52
PID dancer roll control, 8-56
PID fixed setpoint, 8-54
PID motorized potentiometer, 8-54
PKW mechanism for processing parameters, 8-28
Positioning ramp down, 8-143
Power module protection, 8-157
Power Modules
Fitting the Control Unit to the, 4-2
Process dynamisation, 8-102
PROFIBUS DP
Extended functionality, 5-92
PROFIBUS DP
Setting the address, 5-77
Switch over behavior, 5-86
PROFIBUS DP
Conversion of extended functionality, 5-93
PROFIBUS DP DIP switches, 3-14
PROFIBUS DP Interface, 4-10
To Next Page
Loading...
