Siemens CU240S DP-F - Page 409

Index
Control Units CU240S
Operating Instructions, 11/2006, A5E00766042B AA
Index-3
PROFIBUS DP parameters, 5-79
PROFIdrive Profile
User data structure, 5-77, 5-82
PROFIsafe Parameters, 5-100
PROFIsafe telegram structure, 5-85
Properties of the DPV1 parameter channel, 5-93
Protective functions, 3-4
R
Ramp-function generator, 8-61
Reducing the output frequency, 8-158
Reducing the pulse frequency, 8-158
Reset to the factory setting, 5-60
Rules regarding hot swap, 6-11
S
Safe Stop 1 function, 8-110
Safely-Limited Speed function, 8-114
SafeTorque Off function, 8-107
Safety notes
Commissioning, 2-3
Dismantling and disposal, 2-5
General Warnings, Cautions and Notices, 2-2
Operation, 2-4
Repair, 2-4
Safety Instructions, 2-1
Transport and storage, 2-3
Selecting the command source, 8-1
Selecting the setpoint source, 8-1
Self certification, A-1
Setpoint channel, 8-59
Siemens standard Control, 8-42
SIMATIC S7
BICO connection, 5-83
Installing a G120 GSD file, 5-99
Read parameters, 5-102
Slip compensation, 8-165
Speed controller, 8-175
speed encoder
Flying restart with, 8-98
Flying restart without, 8-97
Stall limiting, 8-184
Standard telegram structure, 5-83
Standard telegrams, 5-83
Standards, A-6
STARTER
Download, 5-49
Upload, 5-49
Status display, 7-4
Status word, 5-87
Swapping a CU, 6-12
Swapping the PM, 6-12
Switch over behavior, 5-86
T
Technical construction file, A-1
Telegrams, 5-82
Temperature sensor, 8-155
Terminal layout, 3-12
Thermal monitoring functions, 8-158
Thermal motor model, 8-152
Thermal motor protection, 8-150
Time controlled forced dynamisation, 8-101
Torque limiting, 8-183
Troubleshooting
with the OP, 7-13
TTL Encoder, 5-109
U
Underwriters Laboratories, A-6
Universal Serial Interface, 8-22
Upload parameter, 5-15, 6-2
Upload parameters, 5-47
Used telegram types, 5-83
USS, 8-22
V
V/f control, 8-160
Vdc_max controller, 8-139
Vector control, 8-169
with speed encoder, 8-174
without speed encoder, 8-172, 8-174
VIK/NAMUR telegram structure, 5-84
Voltage boost, 8-163