Technical data
9.2 Technical data of PROFIBUS DP
Control Units CU240S
9-2 Operating Instructions, 11/2006, A5E00766042B AA
9.2 Technical data of PROFIBUS DP
Technical data
To display information about the current operating state of the inverter and the
communication link, the PROFIBUS DP has three LEDs on the Standard Control Unit and
seven on the Control Unit with fail-safe functions.
Its voltage is supplied through the inverter system connector.
The PROFIBUS DP is connected to the PROFIBUS system using a 9-pin sub-D type socket
according to the PROFIBUS standard. All connections to this interface are short-circuit-proof
and isolated.
The PROFIBUS DP supports baud rates of 9.6 kbaud to 12 Mbaud.
To Next Page
Loading...
Need help?
General
